Dual head combo alows for multiple configurations.
Vise Grip with a set of Duckbills and 5/8” Baby Pin. Use for clamping Foam Core, Bead Board, or other reflective boards.
Clamps anywhere onto your standard Flat Gel Frame, adding an additional 5/8” pin for added support when needed
Irwin Chain Vise Grip with 2 welded 5/8” Baby Pin
The Crows Foot is a great alternative to traditional nail on plates.
Allows for the use of 5/8″ Baby Pin to 1-1/8″ Junior Reducer. Machined from aluminum.
Allows for the use of 5/8″ Baby Pin to 1-1/8″ Junior Reducer. Machined from solid steel
Available in 6mm to 3/8 male thread, 8mm to 3/8 male thread, & 10mm to 3/8 male thread
Available in 3/8″ male thread welding on body starter from large, mini-flat large and mini-flat small.
Standard Mitchell male with Castle Nut to 1-1/4” or 1-1/2″ vertical receiver
Standard Mitchell male with Castle Nut to 1-1/8” Junior receiver
Constructed out of steel. Junior receiver with junior pin at a 90 degree angle.
Junior Offset Arm with 1-1/8” male pin with a 1-1/8” receiver opposite
Triple Header allows you to mount 3 lights or monitors onto a single stand
Constructed out of Aluminum for light weight and durability
5/8” Baby Risers allow you to add additional height to stands, baby plates, or any 5/8” Baby Pin
3/8″ Thread Male
3/8″ Thread Female
Available in 5″ and 9.75″
Go from 5/8″ rod to a baby pin
Solid base plate w/ 5/8″ pin
Solid 6″ square base plate with a Jr. receiver
Solid 6″ square base plate with a junior pin
Solid 4″ square base plate with D-Ring
CHECK OUT OUR OTHER PRODUCTS